Before upgrading WAP54G to MustDie 2.07 revision 1 firmware you MUST upgrade your WAP54G to the Linksys 2.07 firmware, following to the letter all Linksys instructions. Failure to do so may cause your WAP54G to break and may require sending it to the manufacturer for replacement.

After upgrading the firmware to MustDie 2.07 revision 1 you MUST do a HARD RESET of your WAP54G. Please remember the settings (especially the encryption keys) before doing a hard reset.


THIS FIRMWARE IS PROVIDED "AS IS" WITH ABSOLUTELY NO WARRANTIES. While this firmware is based on Linksys/Cisco 2.07 GPL tar-ball, the modifications made allow user to force WAP54G to work outside of the parameters specified by manufacturer of the WAP54G or its components, which in turn may cause damage to the WAP54G. In such cases Linksys/Cisco may (and probably will) refuse warranty service for the damaged WAP54G.  
  
Setting "Transmitter Power" to the level above the one allowed by the FCC (or a similar agency of your country/region) MAY CAUSE HARMFUL INTERFERENCE AND A PUBLIC HEALTH HAZARD. You and you alone are responsible for all damages to yourself, your property, others and/or property of others caused by setting the "Transmitter Power" to the illegal levels of RF emissions.  
  
Setting "Channel" to one not appoved by the FCC (or a similar agency of your country/region) for use in your region MAY CAUSE HARMFUL INTERFERENCE and MAY result in you being prosecuted by the FCC (or a similar agency of your country/region).